Structured Wiring
Oops! We could not locate your form.
Does Channel Vision make an extension ring for the 38″ structured wiring enclosures?
Asked By Tech Support – On June 30, 2014 – With Comments OffUnfortunately no, the only available depth extension ring is for the C-0150E 50″ enclosure, the model number is C-1351.
View QuestionI just purchased a C-0150 50″ panel and the C-0150D 50″ cover and wanted to make sure this is the correct cover that fits it?
Asked By Tech Support – On June 17, 2014 – With Comments OffYes the C-0150D is the correct enclosure door cover for the C-0150E enclosure. Both are 50″ and are designed to be used together.
View QuestionI have a C-0332 1×16 amplified splitter. If I were to connect a cable directly to the center input without first going through the amplifier, would it just act as a normal 8 way splitter?
Asked By Tech Support – On June 09, 2014 – With Comments OffYes, if you were to go into the input of either the left or right 8 way splitters they would act as normal non-amplified 8 way splitters, but at this point the signal would experience insertion loss of the decibel value. Usually 8 way splitters will give you an 11 dB loss when not amplified ...
View QuestionDoes the C-0333 fit into a 28″ structured wiring enclosure vertically or horizontally? If so do I need to ad an extension ring?
Asked By Tech Support – On May 12, 2014 – With Comments OffThe C-0333 fits into the 28″ enclosure horizontally without the need for an extension ring. This applies to all Channel Vision structured wiring enclosures.
View QuestionWhat is the RJ-45 wiring configuration used for the C-0436 Telephone distribution module?
Asked By Tech Support – On May 12, 2014 – With Comments OffThe C-0436 uses the T568A standard wiring for RJ-45 termination.
View QuestionDoes the C-1322 fan kit for designer doors stay on or does it click on at a certain temperature?
Asked By Tech Support – On April 21, 2014 – With Comments OffOnce connected and powered, the C-1322 fan kit stays on all the time.
View QuestionDoes Channel Vision manufacture any splitters for Satellite cable distribution?
Asked By Tech Support – On March 28, 2014 – With Comments OffNo, Channel Vision does not manufacture any splitters that are able to to pass the frequency that Satellite Cable uses.
View QuestionDoes Channel Vision sell POE switches? I could not find any on the website.
Asked By Tech Support – On March 28, 2014 – With Comments OffChannel Vision does sell two models of switches, the C-0588 which is an 8 port gigabit switch, and the C-0555 which is a 5 port gigabit switch, however neither of these products are POE (power over Ethernet).
View QuestionCan I use the T568A standard on the C-0538 data distribution module?
Asked By Tech Support – On March 28, 2014 – With Comments OffNo, you may cause damage to the unit which would not be covered under warranty. Only use the advised T568B standard with the C-0538 data distribution module.
View QuestionHow do I remove the hole covers on the sides of my C-0138E enclosure once it’s installed in the wall?
Asked By Tech Support – On March 25, 2014 – With Comments OffOnce the enclosure is installed in the wall you cannot remove the hole covers on the sides. This would need to be done prior to installing. You can remove the enclosure, then remove the hole covers and reinstall. Please note you will also have to create a hole in the stud as well otherwise there ...
View Question