Free System Design Service

Part's and Accessories

How many conductors does the IR-3001 use?

Asked By – On January 29, 2014 – With Comments Off

The iR-3001 uses two conductor. One is signal, and one is ground.

View Question

Is the AB-303 available in any color other than white?

Asked By – On November 26, 2013 – With Comments Off

The AB-303 is currently only available in white.

View Question

What is the frequency range that passes through the 2114?

Asked By – On July 17, 2013 – With Comments Off

It passes up to 4GHZ.

View Question

What is the contact resistance of the 2114?

Asked By – On July 17, 2013 – With Comments Off

The contact resistance of the 2114 is 0.003 Ohms max at DC 1amp.

View Question

What is the insulation resistance on the 2114?

Asked By – On July 17, 2013 – With Comments Off

1000 MegaOhms min at 500vDC.

View Question

What is the voltage rating of the 2114?

Asked By – On July 17, 2013 – With Comments Off

500VAC.

View Question

How do the speaker wires connect to the CC-372?

Asked By – On July 15, 2013 – With Comments Off

On the wall, this connection is made with the J-BPR or J-BPB banana plug jacks. Rotate the connecting pins on the banana plug counter-clockwise to reveal the hole. Tightly twist part of the bare wire and insert into the hole. Verify that polarity matches on each + and – wire going back to the speaker. Then, ...

View Question

A4623 4 Input 6 Zone Amplified A/V Controller

Asked By – On March 19, 2013 – With 1 Answer

I have the 4623 amplifier, and the sound from the speaker outputs is lacking bass, and treble is too high. As there are no knobs to adjust is it possible to adjust inside unit? I can’t use the speaker outputs as the quality is quite poor, which defeats the purpose I bought it for. I ...

View Question
Page 1 of 3